Ontdek onze onderdelen en componenten voor transport- en zeefbanden – geschikt voor elke agrarische toepassing. Vragen? Neem gerust contact op via sales@broekema.nl.

Home / Producten / Spijlen / Volberubberde en gevulkaniseerde spijlen / Steunspijlen

Support rods

Support rods are partially rubber-coated bars used in flight sections of sugar beet harvesters. The rubber is typically applied along the full length of the round section to reduce both wear and noise.

Web width	Belt width	CTC	Rod Ø	Rubber length	Rivet Ø
800	75	30	19	610	6
800	75	32	19	610	6
800	60	30	19	635	6
800	60	32	19	635	6
820	60	30	19	660	6
850	75	32	19	660	6
900	75	30	19	710	6
900	75	32	19	710	6
900	60	30	19	735	6
900	60	32	19	735	6
1000	75	30	19	810	6
1000	75	32	19	810	6
1000	60	30	19	835	6
1000	60	32	19	835	6
1200	60	32	19	1035	6

A practical solution for reducing wear and vibration.

Rubber coating prevents steel-on-steel contact

Reduces noise and wear

Available for standard beet harvester widths

Lightweight and easy to install

Support rods are designed to reduce wear and noise in elevator flights—particularly in sugar beet harvesters. These rods are partially vulcanized, typically with a rubber coating along the round section only, leaving the flattened ends uncovered. This makes them an ideal choice when full rod coverage is not required, but damping is still needed where the rod contacts metal components.
For full-surface protection across both the shaft and the ends, consider our Fully Rubberized Rods.